HP 403349-003 - Manual (Page 47)

Removal and replacement procedures 47
4. Using a T-25 Torx driver, secure the horizontal shipping bracket to the MCS unit by inserting four
Torx screws.
Condensation pump and sensors
The condensation pump and sensors are components of the water group located at the bottom interior of
the MCS unit.
The following tools are required for installation:
• T-25 Torx driver
• Phillips screwdriver
Removing the condensation pump and sensors
1. Power down the MCS unit (" Powering down the MCS unit " on page 24 ).
2. Remove the bottom fan unit (" Removing the bottom fan unit " on page 44 ).
3. Relocate the power inlet box (" Relocating the power inlet box " on page 93 ).
4. Remove the air sealing plate (" Removing the air sealing plate " on page 35 ).