HP 403349-003 - Manual (Page 88)

Removal and replacement procedures 88
Operator display
The operator display is located on the front door of the MCS unit.
The following tools are required for installation:
• 8-mm socket
• Small Flathead screwdriver
Removing the operator display
1. Power down the MCS unit (" Powering down the MCS unit " on page 24 ).
2. Open the front MCS door.
3. Using an 8 mm socket or wrench, remove the three nuts and external star washers securing the
operator display rear cover to the back of the front MCS door.
4. Remove the operator display rear cover.