Honeywell HRXD9 - Manual (Page 23)

Installation
Document 900.0856 Rev 3.00 23
11/07
If you would like to connect your video source to another device, you can use the Loop
BNC connectors.
Note The Loop BNC connectors are auto terminated. Do NOT connect
a cable to the Loop BNC unless it is connected to a terminated
device because it will cause poor quality video.
Connecting the Monitor
Figure 2-4 Video Out Connectors
Connect the main monitor to either the Video Out or SVHS Out connector.
Note Use the SVHS input if your main monitor supports it because it
will give you better quality video display.
Note The Video Out (BNC) and SVHS Out connectors may be
connected to individual monitors for simultaneous operation.
Up to four Spot monitors can be connected to the DVR. Connect the spot monitors to
the SPOT 1, SPOT 2, SPOT 3 and SPOT 4 connectors as needed.
Note When the DVR is in Search mode, it can display live video on the
SPOT 1 monitor as displayed on the main monitor during the live
mode.