Honeywell BENDIX/KING KLN 94 User Manual
Page 30
B
KLN 94
Rev. 4, Jan/2003 10599I04.CDL
Page 2-6
The output can also be converted by a Honeywell KDA 692 which provides standard 4-wire
SINE/COSINE OBI information.
Pin 10; LATERAL DEV FLAG+
Pin 11; LATERAL DEV FLAG-
Pin 12; VERTICAL DEV FLAG+
Pin 13; VERTICAL DEV FLAG-
These are deviation flag outputs. DEV FLAG+ outputs with respect to DEV FLAG-. For the
specifications on these outputs refer to
of this manual.
Pin 14; A/C GROUND
Pin 14 is tied to aircraft ground. Wiring harness shields are not to be terminated on this pin. Refer
to
Pin 15; WAYPOINT ANNUNCIATE
Pin 15 is the Waypoint Alert annunciator output. This output is tied to a remote annunciator lamp.
When the line is pulled low the annunciator lamp will illuminate. The annunciator will be on
whenever waypoint alerting is occurring. For more complete information refer to the KLN 94
Pilots Guide, P/N 006-18207-0000.
Pin 16; MESSAGE ANNUNCIATE
Pin 16 is the Message annunciator output. This output is tied to a remote annunciator lamp.
When the line is pulled low the annunciator lamp will illuminate. The annunciator will be on
whenever the message prompt on the KLN 94 is on. For more complete information refer to the
KLN 94 Pilots Guide, P/N 006-18207-0000.
Pin 17; APPROACH ARM ANNUNCIATE
Pin 17 is the Approach Arm annunciator output. This output is tied to a remote annunciator lamp.
When the line is pulled low the annunciator lamp will illuminate. The annunciator will be on
whenever the unit is in the approach arm mode. For more complete information refer to the KLN
94 Pilots Guide, P/N 006-18207-0000.
Pin 18; APPROACH ACTIVE ANNUNCIATE
Pin 18 is the Approach Active annunciator output. This output is tied to a remote annunciator
lamp. When the line is pulled low the annunciator lamp will illuminate. The annunciator will be on
whenever the unit is in the approach active mode. For more complete information refer to the
KLN 94 Pilots Guide, P/N 006-18207-0000.
Pin 19; ALTITUDE ALERT ANNUNCIATE
Pin 19 is the Altitude Alert output pin. The altitude alert feature can be enabled or disabled at
installation time from the maintenance configuration pages as described in