Honeywell DCP552 Mark II - Manual (Page 20)

2-5
Chapter 2. NAMES AND FUNCTIONS OF PARTS
Parameter setting
Program setting
Changes display channels. FUNC + DISP
Changes the display contents on the message display. MESSAGE
PROG
Changes set program numbers in ascending order.
(In READY mode)
RUN/HOLD Performs RUN operation.
(In READY, HOLD, FAST, or READY FAST mode)
Performs HOLD operation.
(In RUN mode)
PROG + RUN/HOLD Performs RESET operation.
(In RUN, HOLD, FAST, END, or READY FAST mode)
PROG + DISP Performs ADV operation.
(In RUN, HOLD, FAST, or READY FAST mode)
FUNC + ® Performs FAST operation.
(In RUN, HOLD, or READY mode)
A/M Performs MANUAL operation.
(In AUTO mode)
Performs AUTO operation.
(In MANUAL mode)
AT Starts AUTO tuning.
(When AUTO tuning is not in operation.)
Interrupts AUTO tuning.
(When AUTO tuning is in operation.)
­ ¯ ¬ ® Changes numerics during MANUAL operation.
(When the MV or SV display flickers.)
Changes program numbers or segment numbers.
(When the program number or segment number flickers.)
PARA Starts the variable parameter setting. (In basic display status)
FUNC + PARA Starts the event configuration setting. (In basic display status)
PID Starts the PID parameter setting. (In basic display status)
SETUP Starts the setup setting. (In basic display status)
FUNC + PID Starts the fixed command control setting. (In basic display status)
­ ¯ ¬ ® Shifts each item.
ENTER Enters set values.
Completes a change in a set value. (When a set value flickers.)
­ ¯ ¬ ® Changes each itemÕs set point. (When a set value flickers.)
PARA Stops each itemÕs set point. (When a set value flickers.)
DISP Ends parameter setting.
FUNC + PROG Starts the program setting (programming). (In basic display status)
­ ¯ ¬ ® Shifts to program item or segment number.
ENTER Enters set values.
Completes a change in a set values. (When a set value flickers.)
­ ¯ ¬ ® Changes each itemÕs set point. (When a set value flickers.)
Classification
Basic display
status
Changes the display contents.
Key operation
DISP
Function