HP Vectra VE 5/series 2 - Manual (Page 69)

COMPLETING THE INSTALLATION OF A PROCESSOR
1 Verify that the system board bus speed switches are correctly configured for the
processor.
Switch 4 Switch 5 Switch 6 Switch 7 Switch 8
Bus
Speed Processor
Speed
ON OFF ON OFF OFF 60 MHz 150 MHz
OFF OFF ON OFF OFF 66 MHz 166 MHz
ON OFF OFF ON OFF 60 MHz 180 MHz
OFF OFF OFF ON OFF 66 MHz 200 MHz
NOTE If two processors are installed, both must operate at
the same bus speed and processor speed. Refer to
the manual supplied with the processor to verify
which bus and processor speeds are supported.
Note that you must configure your operating system
to use the second processor. Some operating
systems do not support two processors.
1 Install any other accessories before completing the installation of the processor.
2 Replace the cover (see "Removing and Replacing the Cover" earlier in this chapter).
3 Turn on the computer and check that the new processor is recognized by the power-on
system-test.