Heatiator Heatilator Fireplace IDV4833IT - Manual (Page 48)

Heatilator • ICON DV-IDV Series • 4042-575 • Rev. S • 5/11 48
Figure 15.9 Lift Glass Frame Assembly Forward
Figure 15.10 Remove Left Side of Glass Frame First
Decorative
Screen Front
Glass Frame
Assembly
Glass
Latches
Right
Refractory
Panel
Left
Refractory
Panel
Front Hearth
Refractory
Left
Refractory
Shield
Right
Refractory
Shield
Screen
Rod
Figure 15.8 Glass Panel Assembly Removal/Replacement
J. Glass Panel Assembly
Removing/Replacing Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
• Remove three outer refractory pieces as per instructions
in Section 15.L.
• Remove the lower decorative front face by removing the
four screws attaching the face. See Figure 15.16.
• Remove the left and right refractory shields by removing
the three screws holding each shield. See Figure
15.15.
• Remove the decorative fi rescreen mesh. Release the
screen rod from the center screen support. Remove the
right side of the screen rod from the horseshoe-shaped
cradle. Rotate the screen rod down on the right side
until there is enough clearance to remove the screen
completely. See Figures 15.11-15.14.
• Release glass latches (six in IDV4833, ten in IDV6247).
Lift glass frame assembly forward past the glass latches.
See Figure 15.9. Slide the glass to the right (into the
cavity on the right).
• Completely remove the left side of the glass from the
opening before sliding the entire glass panel from the
unit. See Figure 15.10.
• Reverse steps above to replace the glass assembly.