Lucent Technologies Guestworks SErver 1079984G3 - Manual (Page 44)

38 Issue 1 April 1997
Check-In/Check-Out
change system-parameters feature
■ Enter a value in the Call Park Timeout Interval field. This deter-
mines how long a call can remain parked on the server. When this inter-
val times out, the call rings back at the extension that parked the call.
Required Hardware 0
There is no special hardware required for this feature.
Check-In/Check-Out 0
The GuestWorks server can check guests into a hotel and, when the guest
leaves, check them out. There are two ways this is done: through the PMS ter-
minal or through the attendant console (or backup voice terminal).
NOTE:
Check-in and check-out from the attendant console can only be used if
there is no PMS or if the link to the PMS is down. If the PMS is installed
and working, check guests using the PMS.
For guest check-in or check-out from the console, there are two buttons on the
attendant console (or backup voice terminal): one labeled
and the
other labeled . The check-in procedure performs two functions: it
deactivates the restriction on the telephone in the room allowing outward calls,
and it changes the status of the room to occupied.
Check In
Check Out