Polycom Audio and Video User Manual

Page 39

Advertising
background image

Chapter 3 - Configuring Network Use

© Polycom, Inc.

3 - 19

3.

Select

and configure these settings:

The ISDN BRI Numbers screen also displays the country selected as the
system’s location and the Country Code used for international calls to the
system. To specify the system’s location, go to System > Admin Settings >
General Settings > Location

. The system automatically supplies the country

code when you specify the country.

4.

If you have configured

the

ISDN switch protocol to be AT&T 5ESS Multipoint,

NI-1, or Nortel DMS-100, select

and enter the ISDN BRI SPIDs provided

by your service provider.

After you enter the SPIDs, the system verifies them. If the system is unable to
verify the SPIDs, make sure the system is connected and that the ISDN
numbers you entered are correct.

If you do not have the SPIDs from your service provider, you can click Start to
Auto-Detect SPIDs.

ISDN Voice
Algorithm

Enter which voice algorithm (Alaw or uLaw) you want to use for
ISDN voice calls.

Do not change this setting unless you experience audio issues in
all ISDN voice calls.

Auto BRI
Configuration

Check this to allow the NI-1 switch to automatically configure the
directory numbers and SPIDs.

This setting is only available if you have selected the NI-1 switch
protocol.

Setting

Description

Area Code

Enter the area code for this system’s location.

Directory Numbers

Enter the numbers assigned to the B1 and B2 channels for the
BRI line.

The two numbers for a line may be the same or different,
depending on the switch protocol in use.

Enable

Check this to enable the ISDN line.

If you selected the Standard ETSI Euro ISDN protocol, you must
enable the BRI line.

Setting

Description

Advertising