VBrick Systems VBRICK APPLIANCE VB6000 - Manual (Page 108)

98 © 2008 VBrick Systems, Inc.
Audio
Close Captioning
ASF
Frames Per Second Measured rate in frames per second of the encoded video frames
being created by the appliance.
Frames Encoded Increments as compressed frames are produced by the appliance.
VFR Frames Dropped When Configuration: Encoder > Video > Rate Control Method is
configured for Variable Frame Rate (VFR) the encoder may drop
frames to maintain quality and this counter will increment for each
dropped frame. If you experience an unacceptable number of
dropped frames your content is too difficult for your encoder
settings. To improve VBR behavior you can increase the Video
Buffer and/or Target Bit Rate, decrease the Resolution and/or
Target Frame Rate.
Unexpected Frames
Dropped Increments if the encoder is forced to drop a frame for unexpected
reasons. This status indicator is particularly important when
encoding multiple video rates. An excessive number of frame
drops indicates that your combination of resolutions, frame rates,
and bit rates is too difficult for the content you are encoding. See
Configuration: Encoder > Video on page 24 for more
information.
Buffer Full Count Increments when the appliance is in an overloaded condition.
Reduce the load by lowering bit rates or reducing the number of
RTSP and/or HTTP clients.
Bit Rate Measured rate in bits per second of the encoded audio stream
being created by the appliance.
Frames Encoded Increments as compressed frames are produced by the appliance.
Frames Dropped Increments if the encoder is forced to drop a frame for unexpected
reasons. Contact VBrick support if your encoder reports an
excessive number of dropped audio frames.
Buffer Full Count Increments when the appliance is in an overloaded condition.
Reduce the load by lowering bit rates or reducing the number of
RTSP and/or HTTP clients.
Buffer Full Count Increments when the appliance is in an overloaded condition.
Reduce the load by lowering bit rates or reducing the number of
RTSP and/or HTTP clients.
Packets Created
Buffer Full Count Increments when the appliance is in an overloaded condition.
Reduce the load by lowering bit rates or reducing the number of
RTSP and/or HTTP clients.