Status: reflector status, Status: reflector status > general – VBrick Systems VBRICK APPLIANCE VB6000 User Manual
Page 109
Status
VBrick WM Appliance Admin Guide
99
Multicast
Status: Reflector Status
Status: Reflector Status > General
The Reflector Status page displays status based on the selected source. If you select
Push
Receiver
as the
Reflector Source
on the Configuration: Reflector page, you will see "push"
information; if you select
Pull Receiver
, you see the corresponding "pull" information.
Push Receive
Transmit State
Transmitting/Not Transmitting.
IP Bytes Transferred
Total IP Bytes Transferred since last Reset.
IP Packets Sent
Total IP Packets Sent since last Reset.
Push Receiver Status
Pull Receiver Status
Indicates the current state of the reflector receiver.
Started/Receiving
means that the reflector is receiving a stream.
Receiver Source IP
The address of the push source currently sending to this reflector.
Bytes Received
Increments as data is successfully received.
Elapsed Time
The duration of the currently active push receiver connection.
Success Count
Increments each time a push sender initiates a new connection with
this push receiver.