ACU-RITE DRO 200E - Manual (Page 29)

INSTALLATION
DRO 200E
25
Checking Voltage and Connecting Power
Check that the voltage available at the power source is within specification before
connecting it to the readout. If required, set the voltage selector to match the line
voltage.
CAUTION
Connecting the readout to a power source outside
of the acceptable range, or making an inappropri-
ate setting with the voltage selector, may damage
the readout, the scales, or both.
1. Remove the caution label from the
input module, and use a thin-blade
screwdriver in the slot at the top of
the power-input module to open the
module cover.
2. Pull the selection block out.
Rotate the block 180° so the
proper voltage setting will be
seen through the window of
the cover.
3. Remove the fuse, move the shorting
bar to the other side, install the prop-
er fuse, and push the block back into
place.
4. Close and snap the cover shut.
Opening Slot
The voltage setting will show through the window in the voltage selection cover.
Connect the readout to the power source using the power cord supplied.