Velleman HAA2801 User Manual
Page 22
DIRECT ACCESS TO PROGRAMMING MODE WITH THE “DAP” CODE – 8 0 8 0
Set System Into Programming Mode With DAP Code In Case Of The Master Code Is Forgotten ! !
The owner requires to apply the following procedures precisely to set the system into
programming mode with the DAP code
8 0 8 0.
1)
2)
3)
4)
5)
DAP CODE
The DAP code is fixed on
8 0 8 0 and it is valid only in the Power-up Period after the Egress Button
is pressed.
Validate the DAP code with the
* *
(or )
.
2-beep confirms the system is in the Programming Mode; and the Mains LED is constantly ON.
See “RECORD A MASTER CODE” at “Location 01” for the details of programming a new master
code.
NOTES FOR SPLIT-DECODED OPERATION:
1. It is necessary to press the Egress Button on the keypad unit once to enable the DAP function.
2. In Split-decoded mode, the Egress Button is connected to the controller unit but not to the keypad.
The owner has to use a short wire to make a momentary touch of the "EG IN" terminal of the keypad
to "GND (-)" to simulate of pressing the Egress Button in order to enable the DAP function.
3. This procedure is required for both Master keypad and Slave keypad in Split-decoded operation with
DAP Code going into programming mode.
Switch OFF all the power for 1 minute to ensure that the system is fully discharged.
Switch ON power again. The system is in Power-up Mode for 1 minute and the buzzer gives
beeps during the whole period. This is the only time limit for setting the system to Direct Access to
Programming (DAP).
Press the Egress Button (EG IN) once first to enable the DAP function.
Key in the DAP Code
8 0 8 0 and validate it with
* *
(or ),
the existing Master Code in
the memory is erased and the power up beep stops. The keypad turns itself into programming
mode like using the Master Code and it is ready to accept the new programming data.
If the Egress Button is not pressed and the DAP code is not keyed in within the power up period, the
system will set itself to normal operation mode. To set it back to power-up mode, repeat procedures
1-4.
8080
**
DAP CODE
VALIDATION
.
.
.
.
EGRESS BUTTON
PRESS ONCE
22
INDIVIDUAL