Asus ASMB3 - Manual (Page 32)

2-18 Chapter 2: Installation
ASMC Help Menu options
2.5.1 Configuring the LAN controller
Before you can establish connection to the ASMB3-SOL board, you must configure
the LAN port for server management used by the remote server to connect to the
local/central server.
To configure the LAN port of the remote server:
1. On the prompt, type asmc -init_asmb, then press <Enter>. The screen
displays the auto-detected information including the system/motherboard
name, and the IPMI2.0 interface. The screen also shows the status of the
ASMB3-SOL.
Options Description
-flash -load filename Update the ASMB3-SOL firmware
-sdr -save filename Save the SDR data to file
-sdr -load filename Update the SDR data from file
-kcs[smic/bt/pci_smic] NetFn command data.... Send IPMI command
-bmc_ip [ip_addr]
(e.g., bmc_ip 10.10.10.20)
Write the BMC IP address
--pet_ip_mac [ip_addr] [mac_addr]
(e.g., pet_ip_mac 10.10.10.20 010203040506)
Write the PET destination IP and MAC
addresses
-adm_name new_name_string Change the administration name
-user_name new_name_string Change the user name
-adm_password new_adm_password Change the administration password
-user_password new_user_password Change the user password
-init_asmb Initialize ASMB3-SOL
-sol_baud [baud rate]
(e.g., sol_baud 57600)
Set the communication Baud rate
-bmc_info Displays the BMC and PET IP and
MAC addresses
*-bmc_submask subnet mask Write the subnet mask
*-bmc_gateway gateway address Write the gateway address
c:\dos>asmc -init_asmb
Detect System -> DSBF-D/SAS
Detect Motherboard -> (DSBF-D/SAS)
Detect KCS Interface
Initial BMC O.K.
The options marked with * may not be available for all ASMC utility versions. If
your bundled utility does not include these options, refer to the section below to
manually configure the items.
2. Shut down the remote server, then disconnect the power plug from the
electrical socket to initialize the ASMB3-SOL.