Alpha Technologies Cordex Controller Ver.2.0 - Manual (Page 35)

Visit the Alpha website at www.alpha.ca for the latest manual and product downloads
Alpha Technologies Ltd. 034-136-C0 Rev B WC
Printed in Canada. © 2010 Alpha Technologies Ltd. ALPHA and CORDEX are trademarks of Alpha Technologies Ltd. All Rights Reserved. Page 33 of 122
7.
Figure 26–Firmware upgrade procedure
NOTE: Repeat the steps above choosing Shunt MUX as required.
6.1.3 Set ADIO Module Number
This menu item enables the Supervisor to select and map the order number in which CAN-enabled system
devices, such as Battery Cell Monitor (BCM), are to appear in the CXC menus; shown in the examples below:
Figure 27–ADIO Modules and Swap Modules windows
NOTE: When replacing ADIO modules, assign the new identical device with the same ADIO module number of the old
device. This is to preserve the functionality of any equations that use signals originating on the old device.
6.1.4 Site Information
6.1.4.1 System Number
This is where the power system number is displayed/edited.
6.1.4.2 System Serial
This is where the power system serial number is displayed/edited.
Figure 28–Site Information and Contact Information windows
Select module for mapping;
e.g. module 2
Discard changes and
return to previous screen
Accept changes and
return to previous screen
Tap arrows to
increase or decrease
value as required
The module number is
important when any of the
signals from an ADIO device
is used for custom signals or
data logging.