Alpha Technologies Cordex Controller Ver.2.0 User Manual
Page 98
Refer to the back of this manual for Factory Service and Technical Support contact information
Alpha Technologies Ltd.
034-136-C0 Rev B WC
Printed in Canada. © 2010 Alpha Technologies Ltd. ALPHA and CORDEX are trademarks of Alpha Technologies Ltd. All Rights Reserved.
Page 96 of 122
9.2.3
Direct Connection Properties
Right-click on the DIRECT CONNECTION icon to verify the properties of the new connection as follows:
Figure 106–Direct Connection Properties
General Tab
Select a device COMMUNICATIONS CABLE BETWEEN TWO COMPUTERS…
as shown above.
Options Tab
Uncheck PROMPT FOR NAME…
Security Tab
Check TYPICAL (RECOMMENDED SETTINGS) and select ALLOW UNSECURED
PASSWORD.
Networking Tab
Select PPP type. Ensure component TCP/IP is checked and uncheck all others.
Sharing Tab
No changes are required.
9.2.3.1
Modem Configuration
Under the General tab of the Direct Connection properties click on the CONFIGURE button to
open the Modem Configuration window and set the COM port speed to match with the server’s
baud rate; typically 57600 bps as below:
Figure 107–Modem Configuration
Select Configure
to set the parameters for
Modem Configuration.
Uncheck all
Set the COM port speed to match
the server, typically 57600 bps.
Select OK (a second time) to close
the Direct Connections Properties
window.
Select OK to close window