CHIEF KWT110 - Manual (Page 18)

KWT-110 Installation Instructions
18
Figure 35
2. Reinstall side cover to wall track accessory after locking
plate brackets have been inserted. (See Figure 35)
3. Use 1/8" hex key (BB) to install #10 button head cap screws
(V) through #10 washers (N) and wall plate (H) into center
holes of locking plate brackets (J). (See Figure 35)
4. Ensure wall plate (H) is vertical, then tighten screws (V).
(See Figure 35)
WARNING: Overtightening screws may cause wall bracket
to compress into wall track accessory surface, resulting in
difficult mount installation or improper engaging of set screw
in later step.
5. Insert top of Centris display mount (B) over lip on top of wall
plate (H) on preferred location. (See Figure 36)
6. Swing Centris display mount (B) down flush against wall
track accessory (A). (See Figure 36)
Figure 36
2
(J) x 2
(V) x 2
(N) x 2
(H)
1
3
(B)
(H)
(A)