CHIEF KWT110 - Manual (Page 24)

KWT-110 Installation Instructions
24
CAUTION: Ensure that adequate cable slack exists for
movement of keyboard and mouse, and that cables will not
be pinched when bracket is closed.
2. Carefully insert cables into bracket. (See Figure 53)
Figure 53
3. Close cable management bracket by sliding it back towards
the centerline of the arm.
NOTE: If necessary, cable management bracket attach screws
may be tightened using 3/16" hex key (Z).
4. Carefully insert cables in cavity located in lower portion of
mount arm. (See Figure 54)
5. Using Phillips screwdriver, install cover (L) with two #8-32 x
3/8" Phillips flat screws (W). (See Figure 54)
Figure 54
6. Tuck cable inside cable management flap. (See Figure 55)
7. Remove side cover to wall track accessory.
8. Pull cable through cable management flap until cable outlet
plug extends outside the wall track accessory. (See Figure
55)
9. Reinstall side cover making sure the cable runs through the
cable hole. (See Figure 55)
Figure 55
Display Mount Adjustments
Swing Arm
PIVOT / SWING
1. Using 3/16" hex key (Z), slightly loosen or tighten the
adjustment screw(s) as necessary. (See Figure 56)
Figure 56
Height Adjustable
1. Using 5/32" hex key, slightly loosen or tighten the
adjustment screw as necessary. (See Figure 57)
• If display settles on its own, then rotate
adjustment screw counterclockwise (towards the
"+" symbol).
• If display rises on its own, then rotate adjustment
screw clockwise (towards the "-" symbol).
NOTE: It may be necessary to raise or lower the height
adjustable arm to expose the adjustment screw.
Cable Management
Bracket (in open position)
Cable Path (typical)
Cable Path
(typical)
(L) x 1
(W) x 2
1
cable management flap
cable path
4
3
(typical)
Adjustment Screws