Cable management - display mount – CHIEF KWT110 User Manual
Page 23
Installation Instructions
KWT-110
23
Flush Mount Display
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display! Proper screws will
easily and completely thread into display mounting holes.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Inadequate thread
engagement in display may cause display to fall! Back out
screws ONLY as necessary to allow installation of Centris
bracket!
1.
Ensure Centris bracket is able to swivel and tilt easily, yet
still be tight enough to hold display in desired position.
Adjust as required before proceeding.
See "ADJUSTMENTS" for detail.
2.
Using Phillips screwdriver, carefully install two M4 x 12
Phillips pan machine screws (S) into the upper mounting
holes on the display. Thread screws completely into
display, then back out 3 complete turns. (See Figure 50)
3.
Pick up and align display so that screws (S) (installed on the
back of the display in the previous step) fit into the mounting
holes on the Centris bracket; rotate the bracket as required
(See Figure 50). Lower the display into place.
Figure 50
4.
Using Phillips screwdriver, install two remaining M4 x 12
screws (S) through the lower mounting holes in Centris
bracket and into display.
5.
Tighten all four screws (S). Do not overtighten!
6.
Proceed to "CABLE MANAGEMENT."
RECESSED MOUNTING HOLES
1.
Ensure Centris bracket is able to swivel and tilt easily, yet
still be tight enough to hold display in desired position.
Adjust as required before proceeding.
See "ADJUSTMENT" for detail.
2.
Carefully place display face down on protective surface.
3.
Determine depth of recessed mounting holes relative to
back surface of display (against which Centris head will
contact). (See Figure 51)
4.
Select proper length spacer and screw. (See Figure 51)
NOTE: All spacers used should be the same length. If
the recess depths result in multiple spacer
lengths, then select the longer spacer.
5.
Place the four selected spacers over each of the mount
holes on the back of the display.
6.
Pick up and orient the mount (B) so that the mounting holes
in the Centris bracket are aligned with the holes in the
spacers; rotate the bracket as required. (See Figure 51)
Figure 51
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display! Proper screws will
easily and completely thread into display mounting holes.
7.
Using Phillips screwdriver, install four M4 x 20 (T) or M4 x
30 (U) Phillips pan machine screws through the mounting
holes in Centris bracket, through the spacers (Q or P), and
into the display. (See Figure 51)
8.
Tighten all four screws. Do not overtighten!
Cable Management - Display Mount
1.
Open the cable management bracket by sliding it towards
the edge of the arm. (See Figure 52)
NOTE:
If necessary, cable management bracket attach screws
may be loosened using 3/16" hex key (Z).
Figure 52
(B) x 1
(S) x 2
Centris Bracket
(B) x 1
(T or U) x4
(Q or P) x 4
Centris Bracket
OPEN Position
CLOSED Position
Attach
Screws
View from Bottom