Victory HIA-1D-S7-XH - Manual (Page 15)

Figure 2-5
Angle Type Pan Slides
The appropriate amount of uprights are already
installed,when ordered with your cabinet from the factory.
Pan slides cannot be attached to the standard shelf
pilaster. Pan Slide uprights have 1/2” square holes on 1”
centers.
To install an individual slide, locate the appropriate
square holes at the desired height. (A complete section
of slides should be installed by starting at the bottom).
Insert tabs of the slide into the uprights and apply
pressure in a downward direction until the tab fully
engages the upright. Refer to Figure 2-6.
Figure 2-6
Installing Stainless Steel Angle Type Pan Slides
b. Steel Rod Type Pan Slide Racks (Refer to
Figure 2-7)
Steel rod type pan slide racks are also available. They
are designed to accommodate 18” x 26” sheet pans as
follow:
● Bottom Support Pan Slide Rack on 2” centers
● Lip Support Pan Slide Rack on 1-1/2” centers
Uprights for mounting the steel rod type pan slide racks
are factory installed.
Figure 2-7
Steel Rod Type Slides
H. Electrical Supply
The wiring should be done by a qualified electrician in
accordance with local electrical codes. A separate
ground wire must be supplied for all installations.
A properly wired warmer will assure proper operation.
Supply voltage requirements are on the cabinet serial
plate.
It is recommended that a direct, properly fused line of the
proper size wire be installed from the main supply to your
warmer.
Low or high voltage can detrimentally affect the warmer
unit and thereby void its warranty.
All warmer electrical systems are internally grounded. It
is recommended that a bonding braid be secured at the
base of the warmer and carried to a water pipe to
complete the ground.
SECTION 2-INSTALLATION SECTION 2-INSTALLATION
11