Victory HIA-1D-S7-XH - Manual (Page 16)

I. Roll-In Unit Grouting and Sealing
NOTE: It is an N.S.F. requirement that Roll-In models
are sealed to the floor upon installation.
Note: The procedure for setting and grouting the two
section model illustrated below is typical and also
applies to one sections.
WARNING
CARE SHOULD BE TAKEN TO AVOID
GOUGING OR MARRING SURFACE
OR EDGES OF ALUMINUM RAMP.
1. Locate Roll-In model in exact position in which it is to
set permanently.
Note: For reasons of clarity, the illustrations
are shown without doors. Do not remove doors
when installing roll-in models.
2. Level unit, inserting metal shims under unit where
required. It is important that an accurate carpenters
level be used when leveling cabinet. See Figure 2-8.
Figure 2-8
Leveling Cabinet
3. Construct a wood form to act as a retainer for the
grouting compound around the entire base of the
cabinet. See Figure 2-9. Pour the grout mixture at
various intervals around the form to assure complete
fill under the cabinet.
4. Using a wide blade putty knife, taper the grout to a
feather edge.
Figure 2-9
Wood Form Acting As A Retainer
5. A tube of silicone sealer having an applicator type
nozzle is highly suited for sealing Roll-In models to
floor. Cut off a small portion of the applicator nozzle
and apply a small uniform bead completely around
the base of the unit, including the chisel type
ramp(s). Silicone sealer may be feathered at leading
edge of chisel ramp(s) within a given period of time
after it has been applied. Read and follow the
instructions on the tube carefully.
J. Installation Checklist
After the cabinet has been installed, leveled and cleaned
as described in the preceding paragraphs, refer to the
following checklist prior to start-up.
● Full voltage of the correct type, on a line not affected
by the operation of other electrical appliances, must
be available for proper operation.
● Cabinet must be properly leveled.
K. Location of Serial Number / Data Plate
The serial data plate is mounted on the upper left interior
wall.
NOTE: When ordering replacement part, you must
include the complete cabinet model and serial numbers.
SECTION 2-INSTALLATION SECTION 2-INSTALLATION
12