Direct Lift ROTISSERIE - Manual (Page 6)

ROTISSERIE (R3000G) 6 IN50016 Rev. B 03/30/2009
4. Apply good grade lithium shop grease to all sliding parts. This will provide for smooth and
easier operation.
5. Check your mounting point for your particular vehicle. This can be different, depending on
the make/model of your vehicle.
6. With the vehicle on Jack Stands, center the Auto Body Rotisserie bases to the front and
rear of vehicle. NOTE: Sometimes vehicles are heavier on one side and will need to
be offset to that side.
7. Mount the Auto Body Rotisserie Adapter Arms to the vehicle.
8. Place the Connecting Tubes in the center of the Rotisserie unit end pieces and tighten
bolts, Fig. 4. NOTE: Leave one end loose until ready to lift vehicle.
M12 x 1-3/8” Bolts
Connecting Tube
(Outer)
Connecting Tube
(Inner)
FIG. 4
9. Check all mounting bolts to insure they are tightened properly and there is enough distance
between the vehicle and Auto Body Rotisserie unit.
10. Make sure that Rotisserie bases are parallel to each other. Now you can fully tighten the
Connecting Tubes.
11. Now begin lifting the vehicle up with the hydraulic cylinders. Lift just high enough to
remove Jack Stands.
12. NOTE: The vehicle is not centered and balanced and will not spin yet. It will just
swing like a clock pendulum.
See next section for proper “center of gravity” and balancing procedure