LumaStream Trinity PERMANENT User Manual
Page 8
Document: 66APPMAN Rev: H
8 of 32
2.0
SCOPE
The TRINITY LED Driver Dimmer is intended for permanent installations and
powering and dimming Class 2 low voltage lighting systems utilizing either
DMX512A or 0-10Vdc Analog control interfaces.
It is intended for installation in plenum or non-plenum locations in
accordance with required local, state, provincial, country and NEC/CEC
regulations. Only output cables marked with “CMP” may be installed in
plenum locations.
This manual provides general installation, use and application guidelines for
the TRINITY LED Driver Dimmer. It should be read in conjunction with
product datasheets. Data sheets may be downloaded at:
While every effort has been made to ensure the accuracy of the contents of
this manual, LumaStream cannot accept any liability for errors contained
herein. Specifications are subject to change without prior notice.
3.0
OWNER/USER RESPONSIBILITIES
It is the responsibility of the contractor, installer, buyer, owner and user to
install, maintain, and operate the TRINITY LED Driver Dimmer in accordance
with all applicable laws, regulations and local Electrical Safety Authority
requirements. This product is only to be installed by a qualified electrician.
There are no field serviceable parts within power unit.
4.0
EMC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003
requirements.
Warning: This is a Class A product. In a domestic environment this product
may cause radio interference, in which case the user may be required to take
adequate measures.
In order to comply with EN55015 conducted emissions requirements, an
external filter is required that provides a minimum of 10 dB attenuation at
10MHz.
Document: 66APPMAN Rev: H
25 of 32
Note: This wiring configuration provides dimming control for zones 1, 2, 3, and
4 simultaneously with a wall box dimmer or commercial dimming
interface connected to the master 0-10Vdc output of the TRINITY ANALOG.
11.5 Typical Wiring Diagram
Using (1) TRINITY ANALOG and (1) Wall Box 0-10V Dimmer