HP LaserJet P3005 Printer series - Manual (Page 37)

Item Values Explanation
PRINT TEST PAGE: Prints a test page that shows the current
registration settings.
SOURCE: Selects the tray for which you want to print the test
page.
ADJUST TRAY [N]: Sets the registration for the specified tray,
where [N] is the number of the tray. A selection appears for
each tray that is installed, and registration must be set for each
tray.
● X1 SHIFT: Registration of the image on the paper from
side to side, as the paper lies in the tray. For duplexing,
this side is the second side (back) of the paper.
● X2 SHIFT: Registration of the image on the paper from
side to side, as the paper lies in the tray, for the first side
(front) of a duplexed page. This item appears only if the
device includes a built-in duplexer and DUPLEX is ON.
Set the X1 SHIFT first.
● Y SHIFT: Registration of the image on the paper from top
to bottom as the paper lies in the tray.
The default setting for SOURCE is TRAY 2. The default setting
for ADJUST TRAY 1 and ADJUST TRAY 2 is 0.
FUSER MODES List of available fuser modes Configures the fuser mode associated with each media type.
Change the fuser mode only if you are experiencing problems
printing on certain media types. After you select a type of
media, you can select a fuser mode that is available for that
type. The device supports the following modes:
NORMAL: Used for most types of paper.
HIGH2: Used for paper that has a special or rough finish.
HIGH1: Used for rough paper.
LOW3: Used for transparencies.
LOW2: Used for lightweight media. Use this mode if you are
having problems with curled paper.
LOW1: Use this mode if you are experiencing wrinkled media.
The default fuser mode is NORMAL for all print media types
except transparencies (LOW3) and rough paper (HIGH1).
CAUTION Do not change the fuser mode for
transparencies. Failure to use the LOW3 setting while
printing transparencies can result in permanent
damage to the device and fuser. Always select
Transparencies as the type in the printer driver and
set the tray type at the device control panel to
TRANSPARENCY.
When selected, RESTORE MODES resets the fuser
mode for each media type back to its default setting.
OPTIMIZE List of parameters Optimizes certain parameters for all jobs rather than (or in
addition to) optimizing by paper type.
ENWW Configure Device menu 25