Lenovo ThinkVantage (Client Security Solution 8.21) - Manual (Page 21)

Table 8. Options supported by the Lenovo Fingerprint Software (continued)
Parameter Description
SWANTIHAMMERRETRIES Specifies the maximum retries. The default value is 5.
Note: This setting works only when SWANTIHAMMER is
enabled.
SWANTIHAMMERTIMEOUT Specifies the timeout duration in seconds. The default
value is 120.
Note: This setting works only when SWANTIHAMMER is
enabled.
SWAUTHTIMEOUT • 0 = disable authentication timeout.
• 1 = enable authentication timeout.
The default value is 1.
SWAUTHTIMEOUTVALUE Specifies the period of inactivity before authentication
timeout in seconds. The default value is 120.
Note: This setting works only when SWAUTHTIMEOUT is
enabled.
SWNONADMIFPLOGONONLY • 0 = disable fingerprint-only logon for non-Administrator
users.
• 1 = enable fingerprint-only logon for non-Administrator
users.
The default value is 1.
SWSHOWPOWERON • 0 = does not show the power-on security options.
• 1 = always shows the power-on security options.
The default value is 0.
CSS • 0 = assumes CSS is not installed.
• 1 = assumes CSS is installed.
The default value is 0.
Systems Management Server
Systems management server (SMS) installations are also supported. Open the SMS administrator console.
Create a new package and set package properties in a standard way. Open the package and select
New-Program in the Programs item. At the command line type:
Setup.exe /m yourmiffilename /q /i
You can use the same parameters as used for the silent installation.
Setup normally reboots at the end of installation process. If you want to suppress all reboots during
installation and reboot later (after installing more programs), add REBOOT=“ReallySuppress” to the list of
properties.
Chapter 2 . Installation 15