Lenovo ThinkVantage (Client Security Solution 8.21) - Manual (Page 18)

Table 6. Installation examples using Client Security - Password Manager.msi
Description Example
Installation msiexec /i “C:\CSS82\Client Security
Solution - Password Manager.msi”
Silent installation with no
reboot msiexec /i “C:\CSS82\Client Security
Solution - Password Manager.msi” /qn REBOOT=”R”
Silent uninstallation msiexec /x “C:\CSS82\Client Security
Solution - Password Manager.msi” /qn
Installing Client Security Solution 8.21 with existing versions
Client Security Solution can be upgraded from Client Security Solution 8.0 using System Update. To install
Client Security Solution 8.21 with existing versions earlier than Client Security Solution 8.0, first install
Client Security Solution 8.0 to the system.
Client Security Solution 8.0 cannot be installed as an upgrade from a previous version. You must uninstall
your existing version of Client Security Solution before installing version 8.0. To preserve existing data and
settings, complete the following steps before removing the previous version of Client Security Solution:
1. Download the Client Security Solution 8.0 Upgrade Assistant from the following Lenovo Web site:
http://www.lenovo.com/support/site.wss/document.do? sitestyle=lenovo&lndocid=MIGR-46391
2. From the command line, silently run the Client Security Solution 8.0 Upgrade Assistant before removing
the previous version of Client Security Solution.
In addition, Client Security Solution 7.0 users must upgrade to Client Security Solution 8.0 before installing
Rescue and Recovery 4.0
Note: If you are upgrading an operating system, you must clear the security chip to avoid enrollment
failure of Client Security Solution.
Installing ThinkVantage Fingerprint Software
The setup.exe file of the Fingerprint Software program can be installed through the following methods:
Silent installation
To silently install Fingerprint Software, run setup.exe located in the installation directory on your CD-ROM
drive.
Use the following syntax:
Setup.exe PROPERTY=VALUE /q /i
where q is for silent installation and i is for installation. For example:
setup.exe INSTALLDIR="C:\Program Files\ThinkVantage fingerprint software" /q /i
To uninstall the software, use the /x parameter instead of /i:
setup.exe INSTALLDIR="C:\Program Files\ThinkVantage fingerprint software" /q /x
Options
The following options are supported by the Fingerprint Software:
12 Client Security Solution 8.21Deployment Guide