Lukas Concrete crushers - Manual (Page 17)

17
Then fix the recycling unit to the swing bracket (see il-
lustration at left hand side).
First set the weight of the recycling unit on the green
rotating ring on the back of the balancer (see arrow on
illustration at left); this ensures that the cutting unit later
stays at any height position at a later time.
Fix the balancer using the attached hook (see illustration
at right hand side, Item 1) onto the suspension device
provided (e.g. outrigger hooks)
3
Engaging point:
Pull out locked
Engaging point:
Pull out unlocked
2
1
5.4 Mechanical fixing to a balancer from the LUKAS range of acces-
sories
NOTE:
The unit cannot be clamped in the suspension
device!
This is because the recycling unit is mounted
in a rotating manner in the swing bracket.
The swing bracket is fitted with 2 holes in order to balance
out the centre of gravity differences by fixing the shackle
(see illustration at left, Item 2) in the 2nd hole.
The recycling unit should now be aligned
vertically to the steel rope of the balancer (see
illustration at right).
Unlock the balancer by pulling out the
pin (see illustration, Item 3) and then
turn anti-clockwise to the second, slightly
higher engaging point and then releasing
to allow it to engage.