Lukas DUO Traversing System User Manual
Page 15
15
6.1.4 Setting up the roller carriages
The roller carriages are placed on to the rerailing bridges in such a way that the rollers of
the roller carriage are able to move along the rerailing bridges.The guides prevent the roller
carriage from slipping to the side off the rerailing bridge.
- The bridge is horizontally aligned:
The angle of the bridge may not exceed 3°.
If one bridge is not long enough, a second bridge can be bolted on by means of connecting
elements.
For this purpose, the two rerailing bridges are placed end-to-end and bolted together with the
aid of flat steel plates, bolts, washers and nuts (as shown in the picture below). Make sure
that the upper surfaces of the rerailing bridges are not axially offset otherwise trouble-free
traversing may not be guaranteed and/or the individual components may be damaged.
Bridge height
Support width
Max. load
[mm]
[m]
[kN]
[in.]
[ft.]
[lb]
140
1
200
5.51
3.28
44,964
184
1
300
7.24
3.28
67,446
- The maximum load of the bridge connecting elements (optional) is not
exceeded: