Lukas DUO Traversing System - Manual (Page 35)

35
Screws Slide plate
Pin
Narrow
slot
9.3.5 Replacing sliding plate on the traverse jack with anchor jack
The sliding plate must be replaced if it is damaged, bent or broken.
Procedure:
1. Undo and remove the screws on the anchor jack.
2. You can now detach the slide plate and replace it.
3. Assemble in reverse order of removal.Make sure that the pin fitted in the anchor jack
can move in the narrow slot in the slide plate.
9.3.6 Replacing hoses on the traverse jack
All damaged or leaking hoses must be replaced.
Procedure:
1. Unscrew and remove the defective hoses from the jack together with the seals.
2. Place the seals on the hose connections on the jack and screw on the new hoses.
(Tighten to a torque of M
A
= 35 Nm)
NOTE:
If only the hoses are defective and not the couplings, you should first unscrew
the couplings before removing the hoses. After replacing the hose lines, the
couplings are reconnected to the new hoses (see "Replacing couplings").
9.3.7 Labels
All damaged and/or illegible labels (safety signs, type plate, etc.) must be renewed.
Procedure:
1. Remove damaged and/or illegible labels.
2. Clean the surfaces using acetone or industrial alcohol.
3. Attach new labels.
Make sure that the labels are attached in the right position. If you are no longer sure about
this, contact your authorised LUKAS dealer or LUKAS directly.