Gastroback 42399 Automatic Milk Frother - Mini - Manual (Page 5)

• Ensure that the voltage rating of your mains power supply corresponds to the voltage re-
quirements of the appliance (220/230 V, 50 Hz, AC, rated for 16 A). Always connect the
appliance directly to a separately protected mains power supply wall socket with protective
conductor (earth/ground). Do not use any extension cord.
The installation of a residual current safety switch with a maximum rated residual operating
current of 30 mA in the supplying electrical circuit is recommended. If in doubt, contact your
electrician for further information.
• Always unplug the appliance when not in use and before moving or cleaning the appliance.
Do not leave the appliance unattended while connected to the power supply.
• Keep the cord away from hot surfaces, including the stove. When the power cord warms
up during operation or is likely to be damaged, it must be replaced by an authorised service
centre. Do not attempt to repair the power cord!
• Do not immerse the pitcher or power cord in water or any other liquid.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
Hot surfaces – risk of burns
The milk frother is used for frothing and heating milk. During operation the inside of the pitcher
and the lid heat up.
• Dry spilled liquids immediately. When moving the filled pitcher, close supervision is neces-
sary to keep the pitcher in an upright position to avoid spilling, and thus avoid injuries and
damage. Use the handle to lift the pitcher.
• The interior of the pitcher and Lid heat up during operation. Always keep your hands, face
and arm as well as any clothing and other heat-sensitive objects out of the pitcher during ope-
ration or shortly after to avoid injury - risk of getting burned. Wait for the appliance to cool
down. Do not place any objects or clothes on or in the appliance during operation to avoid
overheating. Before filling the pitcher ensure no foreign objects are inside the pitcher.
• Always place the appliance on a stable, level, dry, heat-resistant and easy accessible sur-
face (i. e. glass, ceramic, stone).
• Ensure the appliance is properly assembled, the attachment is locked in position and the
correct amount of milk is filled into the pitcher before turning the appliance on. Do not overfill
the pitcher.
• Always keep the lid except flavour hatch closed during operation. The rotation of the at-
tachment during operation can cause spilling when the lid is removed. Do not hold your face,
hands, other parts of your body, or heat-sensitive objects over the lid or spout, and always
beware of hot steam, when opening the lid after operation to avoid scalding.
• Never place any heat-sensitive objects on the appliance when in use to prevent damage
from heat, condense water and splatter.
• Unplug from outlet when not in use and before cleaning. Allow the appliance to cool before
assembling or disassembling parts, and before cleaning the appliance.
• Never operate the appliance without milk, water, or other appropriate ingredients in the
pitcher. Failure to do so can result in damage to the appliance. If a problem appears, return
appliance to an authorised service centre or factory for repair. Do not attempt to repair. Appli-
ance contains no user serviceable parts.
21