Technical specifications, Before first use – Gastroback 42399 Automatic Milk Frother - Mini User Manual
Page 6
22
• Do not use appliance for anything other then intended use.
• Ensure the froth whip and the whip holder are correctly assembled.
• Beware of hot steam when removing the lid.
• WARNING: When making froth or hot beverages, the heated liquid is hotter than the
froth. When serving, especially to children, wait briefly for heated liquid to cool down and sip
cautiously.
• ATTENTION: Your milk frother´s pitcher is made of high quality PYREX Glass. The pitcher
should not come in contact with a cold liquid (including tap water) or surface for about three
minutes following the completion of the frothing process. Despite its strength, the Pyrex frothing
pitcher can break due to a sudden temperature change to your pitcher. After the three minute
period, add a little warm or hot water to the pitcher, and then the frothing pitcher can be
cleaned as specified in the ›Care and cleaning‹ instructions. Remember, however, to rinse with
cold water prior to initiating a new frothing cycle.
Technical specifications
Model:
Art.-No. 42399
Automatic Milk Frother - Mini
Power supply:
230 V AC, 50 Hz
Power consumption:
500 W
Length of power cord:
ca. 1.4 m
Weight:
ca. 1 kg
Dimensions: (width x height)
ca. 16.5 cm x 22 cm
Certification:
Before first use
Carefully unpack the appliance and remove any promotional material attached to the pitcher,
but do not remove the warning or model labels on the appliance.
ATTENTION: The milk frother is used for heating and frothing milk. Never fill other foods
inside the pitcher.
Before cooking, insert the plug into the outlet on the body, and the power supply plug into the
socket outlet
WARNING: Always connect the appliance directly to a separately protected mains power
supply wall socket with protective conductor (earth/ground) connected properly. Do not use
any extension cord.
Always attach the power plug to the appliance first, then plug the cord into the wall outlet. To
disconnect, turn unit’s control switch to OFF, then remove the power plug from the wall outlet.