Gastroback 42399 Automatic Milk Frother - Mini - Manual (Page 8)

After approximately 1½ minutes of frothing, or when the frothing pitcher be-
gins to feel warm, press down on the flavour hatch so that it opens fully and
the pouring channel is exposed. Pour desired amount of flavouring into the
pitcher. Push back the end of the flavour hatch forward and down to close.
Note: As a safety feature, the milk frother cannot be restarted immediately
after reaching its shut off temperature. Wait approximately three minutes for
the appliance to cool off and then pour cold water into the pitcher.
If you prepare more froth than you require and the remaining froth in the
pitcher has lost some of its richness, or the froth temperature has declined,
you may refresh the froth to its original richness and temperature by simply
pressing the ON switch.
7. Allow about 30 – 60 seconds for the hot milk to settle. Then, unplug the
power cord, and using the spout, carefully pour the desired amount of hot
milk for Cappuccinos, Lattes or other specialty drinks.
Remember that liquid milk heats to a higher temperature than
froth. When serving to children, wait until the hot milk cools
down slightly or stop unit early by pressing the OFF switch.
8. Remove the lid from the frothing pitcher, place the lid upside down on the counter to mini-
mize any milk spillage, and then spoon out the rich froth.
Note: After use, clean your appliance following the ›Care and cleaning‹ instructions.
Between consecutive cycles, the unit must be rinsed with cold water. Wait for approximately
three munutes and then pour water into the pitcher. To help cool the pitcher, allow cold water
to remain in the pitcher for a few minutes.
After 4 consecutive cycles, the appliance must be shut off for approximately 10 minutes.
Caution: Only liquids or powdered mixes can be used. Solid food items must not be used
while the appliance is operating as they may cause damage to the froth whip.
Care and cleaning
Before first use and after each use, it is important that you clean your milk frother following the
guidelines below. You should wait for approximately three minutes and then rinse the pitcher
in cold water between consecutive cycles.
• ALWAYS UNPLUG POWER CORD FROM UNIT PRIOR TO CLEANING AND
NEVER IMMERSE IN WATER.
• To allow the froth whip to be thoroughly cleaned, remove the lid from the frothing Pitcher
and hold the lid with the whip facing upward. Remove the whip and tha whip holder by firmly
grasping the whip holder and pulling outward and away from the lid. You may also remove
the whip from the whip holder by securely grasping the whip holder with your thumb and
forefinger and turning the whip counterclockwise one quarter turn. Carefully pull the whip out
of the whip holder. Never remove the froth whip by pulling on the frothing blades.
24