Cub Cadet MTD P71 Series User Manual
Page 106
P71 Series Vertical Shaft Engines
100
9.
Install the cylinder head by following the steps described in Chapter 9: Cylinder head.
10.
Install the muffler by following the steps described in Chapter 8: Exhaust.
11.
Install the flywheel and module by following the steps described in Chapter 7: Ignition system.
12.
Install the blade brake, if equipped.
13.
Install the fuel tank by following the steps described in Chapter 4: Fuel systems and Governor.
14.
Install the carburetor by following the steps described in Chapter 3: Air Intake and Filters.
15.
Install the blower housing and starter by following the steps described in Chapter 6: Starter.
16.
Install the engine on the application by following the steps described in the application’s service manual.
17.
Install the spark plug by following the steps described in Chapter 7: Ignition system.
18.
Fill the engine with oil and fuel by following the steps described in Chapter 1: Introduction.
19.
Test run the engine in a safe area and make any carburetor and governor adjustments needed.