Cub Cadet MTD P71 Series - Manual (Page 57)

F UEL S YSTEM AND G OVERNOR
51
Governor shaft
To remove or replace the governor shaft:
1. Remove the engine from the unit.
2. Remove the governor arm by following the proce-
dures described in the governor arm section of this
chapter.
3. Remove the sump by following the steps described in
Chapter 10: Disassembly.
4. Remove the hair pin clip from the governor shaft. See
Figure 4.29.
5. Remove the flat washer. See Figure 4.30.
6. Slide the governor shaft out of the engine block from
the inside of the engine. See Figure 4.31.
Figure 4.29
Hairpin clip
Figure 4.30
Flat washer
Figure 4.31