IC Realtime 2Mp 30x Optical Zoom Full HD Network PTZ Dome Camera with 300ft IR (ICIP3001HDIR) User Manual
Page 18
12
Move the cursor to SITE INFORMATION and then click confirm button.
z
ADDR TYPE: There are two options: soft and hard. Please use the left/right button on the keyboard or
in the speed dome terminal menu to set. Please click the OK button to confirm
z
ADDR-HARD: It is an address you set in the dial switch. You can not modify it through software.
z
ADDR-SOFT: You can set address via software. It is to say, you can use menu to modify dome address.
The value ranges from 0 to 255.
z
BACK: Go back to the previous menu.
z
EXIT: Log out system menu.
4.4.2 Display
Setting
Move the cursor to DISPLAY SETUP and then click confirm button, you can go to the third submenu. Please
use the left/right button on the keyboard or in the speed dome terminal menu to set. After completed setup,
please click save button to save current setup.
z
PRESET TITLE: Display dome preset title or not. Please use the left/right button on the keyboard or in
the speed dome terminal menu to set. You can go to Function Setup->Preset section to set
corresponding preset value and preset title.
z
AZIMUTH DISP: Display dome current coordinates or not. Please use the left/right button on the
keyboard or in the speed dome terminal menu to set
z
TIME DISP: Display dome system time or not. Please use the left/right button on the keyboard or in the
speed dome terminal menu to set.
z
POSITION: Display the angel between the benchmark and then current location. Please use the
left/right button on the keyboard or in the speed dome terminal menu to set.
z
ZOOM DISP: Display speed dome zoom speed or not. Please use the left/right button on the keyboard
or in the speed dome terminal menu to set.
z
INSIDE TEMPERATURE: Display dome internal temperature or not. There are three options:
℃/F/Off.
Please use the left/right button on the keyboard or in the speed dome terminal menu to set.
z
TITLE DISPLAY: Here you can set to display speed dome position information and etc. You can use the
speed dome control terminal to set the detailed title information. Please use the left/right button to set.
z
BACK: Go back to the previous menu.
z
EXIT: Log out system menu.
4.4.3 Camera
Setting
Before the operation, please make sure your camera supports the corresponding function.
ADDR TYPE : HARD
ADDR-HARD : 001
ADDR-SOFT : 001
BACK
EXIT
PRESET TITLE ：ON
AZIMUTH DISP ：ON
TIME DISP ：OFF
POSITION ：OFF
ZOOM DISP ：OFF
INSIDE TEMP ：℃
TITLE DISP ：OFF
BACK
EXIT