IC Realtime 2Mp 30x Optical Zoom Full HD Network PTZ Dome Camera with 300ft IR (ICIP3001HDIR) User Manual
Page 26
20
IDLE FUNC
：
OFF
IDLE TIME
：
010MIN
IDLE ACTION ：PRESET
PARAMETER ：NONE
SAVE
BACK
EXIT
From the start position, dome begins auto movement repeatedly.
This series IP dome supports maximum 5 patterns and one pattern can max support 400 commands.
Move the cursor to PATTERN and click confirm button.
z
PATTERN
NO
： Here is to set pattern number. Please click left/right key to configure.
z
PROGRAM START: Here is to memorize pattern starting point. An icon OK pops up in screen to prompt
you system begins memory pattern.
z
PROGRAM
STOP
：Here is to set pattern stop point. After all the movement, move the cursor to
PROGRAM STOP and then click confirm button. Now you have set one pattern. System pops up an
icon OK to prompt you system has memories one pattern.
z
RUN
：Here is to activate pattern. Input pattern number, move the cursor to RUN and click confirm
button, system begins running pattern.
z
STOP: Here is to stop current pattern. Input pattern number, move the cursor to STOP and click confirm
button. System stops current pattern.
z
BACK: Go back to previous menu.
z
EXIT: Log out system menu.
Note:
z
The dwell time between two orders should be less than one minute, otherwise system will set to default
value as one minute.
z
After click PROGRAM STOP, do not click CALL button before icon
“●” disappears completely.
z
Any manual operation during the pattern procedure will terminate current dome pattern operation.
4.4.4.6 Idle Function
When there is no available command for specified time, dome automatically goes on the previous set
functions.
• IDLE
FUNCTION
：
There are two modes ON/OFF. Please use left/right key to set.
• IDLE TIME: System idle period. Please use the left/right button on the keyboard or in the speed
dome terminal menu to set.
• IDLE ACTION：There are several functions you can select:
NONE/PRESET/SCAN/TOURING/PATTERN. Please use the left/right button on the keyboard or in
the speed dome terminal menu to set.
• PARAMETER: It is to set idle motion SN. System can implement the corresponding action when it is
idle for the specified period. Click the left/right button to set.
• SAVE：Move the cursor to SAVE and click confirm button to save current setup.
• BACK: Go back to previous menu.