Keri Systems Doors.NET Manual - Manual (Page 348)

Doors.NET Reference Manual
- 348 -
The program default is to automatically take ownership of all unclaimed controllers.
8. You release ownership of controllers by clearing the corresponding check box.
9. Enter the IP address for each controller. For a small number of units you can dir-
ectly enter the IP Address into the field shown below. Or for a large number of units
you can set a sequential set of IP Addresses by entering the starting IP Address
and the value of the last IP Address.
10. Click the Assign Button to enter the IP Addresses into the program database.
11. Click the Apply Button to complete the Auto Configuration task. Configuration
status for the individual controllers is displayed in the Status Messages window as
individual steps are completed. Controllers requiring
Firmware Upgrades will be
identified. You do not need to take ownership or assign any IP addresses when
auto-configuring PXL controllers, just click the Apply button.
NXT