Keri Systems Doors.NET Manual - Manual (Page 534)

Doors.NET Reference Manual
- 534 -
When the system sees a trigger that you have defined, the event will appear in live
events and at the same time it will execute a procedure that you have defined
(and assigned within the trigger setup).
1. Click the Add Trigger button then highlight the new trigger's description.
2. Change the new trigger's default description within the description field and click
save.
3. From the 'Execute This Procedure' drop-down list select the procedure you wish to
activate when the trigger event occurs.
4. From the 'Procedure Command' list leave it set to the default of 'Execute Prefix A
Actions' to trigger the selected procedure
5. From 'Source Type' choose the specific type of trigger source. i.e an input or output
generated event, a reader event, an event generated by a controller or a time
schedule going active or inactive.
6. The source type list is where you select the specific input, output, controller,
reader, etc which will be the chosen hardware object for creating the trigger.
7. Activate during the schedule is where you define when the trigger will be used.
Always will mean the trigger will always be 'seen'. Otherwise you can choose a dif-
ferent time schedule to restrict it.
8. Finally, trigger variable logic is used for conditional linkage. For example; if you
want to specify two variable that must both be active before the trigger becomes act-
ive. One input on the system might be set to variable 1 and another set to variable
2. Trigger Variable Control allows you to state that BOTH variable must be in a cer-
tain state (i.e both True) before the trigger become active.