Longshine LCS-WA3-50 - Manual (Page 8)

Wireless 11n Access Point
7
1.4 The Rear Panel
The rear panel of the Wireless 11n Access Point is shown below.
 LAN(1~2): Through these ports, you can connect the AP to your PCs and the other Ethernet
network devices.

DC IN: Plug the circle end of the power adapter firmly into the rear panel of the Wireless AP,
and the other end put into an electric service outlet then the system is ready.

Reset Button
Push the button for more than 5 seconds and then release it, the system will return to factory
default setting. In the meantime, system rewrites flash to default value and SYS LED flash for
a while. Approximately 60 seconds later, the SYS LED turn dark, now the whole system
parameters have returned to factory default value. If the process has been interrupted by any
reason (power off), the system will fail. Before performing the process, ensure a safe
operating environment please!
 Antenna: Used for enhancing the wireless signal, and expanding the range of signal.
 WPS: Help users to connect this AP quickly and security. It uses PIN configuration method or
PBC configuration method, in which users can easy setup WPS connection. Please refer to
WPS settings for more information.
Warning
：
Incomplete factory setting recovery procedure will cause the Wireless AP
malfunction
！If you are unfortunately in this situation, do not try to repair it by
yourself. Consult your local distributor for help!
1.5 Placement (Optional)
There are two ways to place the AP. The first way is to place the AP vertically on a surface. The