Toa HX-7W-WP - Manual (Page 6)

6
6. INPUT SECTION
6.1. HX-7B and HX-7W
• The 2 Speakon connectors are internally connected in parallel to the screw terminals; you can use either one.
• The right table shows the pin arrangement of the Speakon NL4MP connector.
• The usable connector (on the cable end) for the Speakon NL4MP is Speakon NL4FC or NL4FX.
• Wiring diagram of the input connectors is shown at right.
• Two speaker systems can be operated in parallel by connecting
them in a cascade configuration as shown at right.
Note
Be sure to connect the speaker system to the power amplifier’s
output terminal of 4 Ω or less.
Connecting it to an output terminal of over 4 Ω may cause
amplifier failure.
Pin No. HX-7B, HX-7W
1 + Speaker +
1 – Speaker –
2 + –
2 – –
Screw terminal
+
–
Speakon NL4MP x 2
1+
1–
2+
2–
1+
1–
2+
2–
Speaker +
Speaker –
First speaker Second speaker