TYREDOG TD-2300A-X10 - Manual (Page 37)

TD-2300A Series V1.0 35
Add new Sensor (LEARNABLE) Continued..
3) While the Red LED on the Relay is still illuminated, insert a Battery
into the LEARNABLE sensor like shown below. Once you insert the
Battery, the monitor will Beep once. Now Press the Reset Button
again on the relay and make sure the Red LED turns OFF and this
will complete the Learning Process.
Note: If the LED on the Relay turns off before you have a chance to
insert the Battery into the Sensor, simply press the Reset button on the
Relay again. (The LED stays Illuminated for 50 Seconds)
+
Push
Reset
Button
Again
LED
ESC CLR
While in Sensor Learn mode, the
Display will look like this. It will either
say Truck Head, Trailer 1 or Trailer 2.
Depending on which relay you are
programming the sensor into.
3) Once the LEARNABLE sensor has been programmed, simply press
the Backlight (ESC) Button to exit.