Dakota Digital SIM-1-GSXR - Manual

FOR
Changing the gearing or tire size
incorrect. The SIM-1-GSXR will allow you to adjust
speed sensors, back to the correct reading
The SIM-1-GSXR has an adjus
to 0.502 times (half). Calibration is set using the two push button switches. Press the UP button to
increase the speed. Press the DOW
memory which stores the calibrat
work/service on the bike.
*Depending how far off your speedometer is
on your speedometer with the SIM
miles per hour.
Typical GSXR Install (3-pin speed sensor
Connection is as follows:
1. Locate the three pin connector between the speedometer and speed sensor
black connector. You will need to remove the seat and lift the tank to locate the
under the tank at the back side of the engine with some of the other wiring.
Image 1
2. Unplug the connector.
3. Plug the SIM-1-GSXR into the two mating connectors. The SIM
between the speedometer and speed sensor. (
4. Re-assemble any removed pieces and leave the SIM
steps below).
5. Once calibrated secure the SIM
Wire ties work well for this.
good spot for mounting (image
SIM-1-GSXR
SPEED RECALIBRATION UNIT
FOR SUZUKI ELECTRIC SPEEDOMETERS
the gearing or tire size on a motorcycle will make the speedometer
will allow you to adjust an electronic speedometer,
, back to the correct reading.
has an adjustable range of correction from 2.84 times
Calibration is set using the two push button switches. Press the UP button to
increase the speed. Press the DOWN button to decrease the speed. The unit has an internal
memory which stores the calibration when the bike is turned off, or if the unit is
how far off your speedometer is, you may NOT register a speed reading
on your speedometer with the SIM-1-GSXR installed until you are traveling faster than 5
speed sensor connectors)
connector between the speedometer and speed sensor
You will need to remove the seat and lift the tank to locate the
under the tank at the back side of the engine with some of the other wiring.
Image 2
into the two mating connectors. The SIM-1-GSXR
between the speedometer and speed sensor. (image 3)
any removed pieces and leave the SIM-1-GSX accessible for calibration
ecure the SIM-1-GSXR into the harness on the bike so it is not hanging loose.
Wire ties work well for this. There is a small space in front of the battery
(image 4).
MAN#650310
speedometer reading
an electronic speedometer, with stock electric
times (more than double)
Calibration is set using the two push button switches. Press the UP button to
The unit has an internal
ion when the bike is turned off, or if the unit is unplugged for any
register a speed reading
until you are traveling faster than 5
connector between the speedometer and speed sensor, typically it is a
You will need to remove the seat and lift the tank to locate the connector; it is
under the tank at the back side of the engine with some of the other wiring. (image 1 and 2)
Image 2
GSXR will now be in
GSX accessible for calibration (see
into the harness on the bike so it is not hanging loose.
under the seat that is a