CUE controlCUE - Manual (Page 10)

10
controlCUE Controllers | Connecting
© CUE, a.s. | All Rights Reserved.
Connecting
CUEnet (LAN)
10/100 BaseT LAN Connector
The 10/100 BaseT LAN is a standard network connection 10/100 BaseT LAN using RJ-45 connector.
The length of the Ethernet cable connecting controller to the network must not exceed 100 meters.
Connector pin out
RJ-45 Pin Signal Cat5 Cable Color
1 TX_D1+ and PoE White / Orange
2 TX_D1- and PoE Orange
3 RX_D2+ and PoE White / Green
4 Blue
5 White / Blue
6 RX-D2- and PoE Green
7 White / Brown
8 Brown
Ethernet cable
straight-through or crossed-over
Direct PC Connection
Attach one end of an RJ-45 Ethernet cable to the CUEnet (LAN) port and attach the other end of the RJ-45
Ethernet cable to your computer. Use straight-through cable if your PC supports autosense or crossed-over
cable if your PC doesn’t support autosense.
LAN Network Connection
Attach one end of an RJ-45 Ethernet straight-through cable to the CUEnet (LAN) port and attach the other end
of the RJ-45 Ethernet cable to your computer.
L G R L G R S G S G S G S G + G 1 2 3 4 5 1 2 3 4 5 S S S S G NC C NO NC C NO + G
PWR IN RELAY GENERAL I/O SERIAL IR/SERIAL AUDIO LINE
CUEnet (LAN)
default IP address
192.168.1.127
IN OUT 1 2 3 4 1 2 1 2 3 4 G 1 2 24 VDC F. D.
Ethernet cable straight-through
L G R L G R S G S G S G S G + G 1 2 3 4 5 1 2 3 4 5 S S S S G NC C NO NC C NO + G
PWR IN RELAY GENERAL I/O SERIAL IR/SERIAL AUDIO LINE
CUEnet (LAN)
default IP address
192.168.1.127
IN OUT 1 2 3 4 1 2 1 2 3 4 G 1 2 24 VDC F. D.
Network