CUE controlCUE - Manual (Page 18)

18
controlCUE Controllers | Connecting
© CUE, a.s. | All Rights Reserved.
CUEwire Device Connection
All controllers are compatible with CUEwire devices as keyboards, keypads, sensors etc.
Serial port SERIAL 1 in mode RS-485 can be used for CUEwire connection as described on picture below. This
port is equipped with 24 VDC output for CUEwire devices power supply.
All other serial ports SERIAL x can be used for CUEwire connection too, but they aren’t equipped with 24 VDC
output. That means CUEwire devices must be powered externally.
See following figure for CUEwire device connection.
L G R L G R S G S G S G S G + G 1 2 3 4 5 1 2 3 4 5 S S S S G NC C NO NC C NO + G
PWR IN RELAY GENERAL I/O SERIAL IR/SERIAL AUDIO LINE
CUEnet (LAN)
default IP address
192.168.1.127
IN OUT 1 2 3 4 1 2 1 2 3 4 G 1 2 24 VDC F. D.