Dimension One Spas 2000 Model - Manual (Page 46)

44
2000 Owner’s Manual
If you decide to drain the spa, drain it as completely as possible. You
may wish to tilt the spa on edge and use a wet-vac or high pressure blow-
er to evacuate as much water as possible. This will require additional
people. Try to get as much water out of the plumbing lines and equip-
ment as possible. If you want to use the spa water on surrounding vege-
tation, make sure that it is free of sanitizers.
When the spa is completely drained, leave the hose bib open and open
the pump drain valve located on the bottom front side of the pump.
Also, loosen all pump unions and fittings to allow air and water to
expand freely within the system. This should prevent water freezing
expansion from damaging pipes and fittings. The key is to eliminate any
sealed areas in the systems that may contain water.
If you receive heavy snowfall during winter months, you may want to
build a cover cap for the spa cover. This can be done with a 1/2” to 3/4”
thick piece of plywood and a few supporting 2” X 4” cross members.
CAUTION: Your spa is equipped with automatic freeze protection.
However, power outages can cause your spa equipment system to freeze
quickly. During freezing conditions, check your spa frequently to ensure
proper operation. Always check your spa after any power failure to
ensure that it is operational. Draining and not operating your spa dis-
ables this feature.
For additional information about winterizing your spa, please contact
your local Authorized Dimension One Spas dealer.
WARRANTY SERVICE INFORMATION
Your spa warranty gives you specific coverage. Be sure to read the
enclosed warranty sheet carefully.
The warranty does not cover problems arising from misuse, abuse, or
neglect, and it does not cover problems caused by improper installation
or “perceived” problems caused by failure to read the spa owner’s manual.
A service charge will be made if a service call is made for any of the fol-
lowing: