Dimension One Spas 2000 Model User Manual
Page 47
45
2000 Owner’s Manual
1) Equipment failure due to improper/inadequate electrical service. All
systems require dedicated circuits as described in this manual. Low
voltage can cause equipment failure and seriously shorten equipment
life. It is the owner’s responsibility to ensure proper electrical service
is available.
2) Failure of spa to reach desired temperature because the set tempera-
ture is not turned up high enough. Maximum thermostat setting is
approximately 106˚ F.
3) Burned out spa light. Bulbs are not covered.
4) Spa water chemistry is the responsibility of the spa owner. Cloudy,
dirty or chemically unbalanced water and cleaning of the spa filter
are also the responsibility of the spa owner.
5) Spa shell or equipment damage caused by improper water mainte-
nance. Serious damage can be caused if your spa water is not main-
tained carefully and correctly.
6) Poor jet action because the jet Selector valve is in the middle posi-
tion. For full performance, turn the jet Selector valve to either the
full clockwise or full counterclockwise position.
WARNING: Do not block air intakes located on the front left cor-
ner underneath the spa (the front right corner for the Chairman II
and Triad II) and under the equipment access panel. Resulting mal-
functions are not covered under warranty.