Guralp Systems CD1.1 - Manual (Page 36)

CD1.1 Tools for Platinum
The Connect host field should be populated with the address
to which the actual data connection should be made. Where
the receiver is running on a CMG-EAM directly connected to the
Internet, this will be the I.P. address of the CMG-EAM and the
port number specified as Bind service, above. If the CMG-
EAM is behind a firewall or NAT device, however, it may be
necessary to specify the I.P. address of the firewall.
Similarly, the Connect service field should be populated with
the port (name or number) to which the incoming connection
should be made, which may differ from the Bind Service port
if NAT or another translation scheme is being used.
The receiver must be configured ahead of time with a list of
DPs from which it is to expect connections. This should be
provided in the Sender list field. If a sending station's
connection request frame contains a name other than the ones
listed in this field, it is rejected. Individual station names in the
list should be separated by spaces.
6.2.2 Configurable parameters in expert mode
The following additional configuration options appear when the
“Expert mode” button is pressed:
The Log file field allows a separate log-file to be maintained,
dedicated to this receiver instance. When left blank, the
standard syslog subsystem is used and, for most applications,
this is adequate. For extremely complex set-ups, it may be
useful to segregate messages from this instance into a
separate file.
Whether logging to syslog or to a dedicated file, the Log level
pull-down menu allows you to select the level of detail that will
be logged. The options are a subset of the standard syslog
36 Issue C