Digimerge DHU104 - Manual (Page 70)

62
Appendix 9: System Setup Tips
Backing up your System Configurations
it is recommended to back up your system
configurations to a Memory Stick.
Configuring your system to meet your
specific needs can be time consuming -
having a backup of your settings will allow
you to reset your unit with your
personalized settings in the event of an
unwanted change.
1. Enter MENU mode by pressing the MENU
button on the front panel of the system (or
on the Remote Control). Select the
SYSTEM SETUP Option.
2. Select the SYSTEM MANAGEMENT
menu from the MAIN menu. Navigate
using the up and down arrows on the front
panel (or remote control). Highlight the
selection in Green, and press the ENTER
button to enter the SYSTEM
MANAGEMENT Menu.
3. Navigate to the System Data option - the
System settings can be saved to a USB
memory stick:
• Insert the Memory stick into the System
and select the Save option to save
settings:
• A Success message indicates that the
backup was completed.
• If the device is not detected, a message
will indicate that No storage device was
found.
• To load your User Settings, Insert the
Memory stick into the System and
select the Load option to restore
settings.
• System Backup is recommended after
initial setup and installation is
complete.
NOTE: Make sure to store your USB flash
drive in a safe place.