Lynx Studio Hilo Version 5 Firmware - Manual (Page 4)

1.2.2.2 Stereo / Mono Options for Input Channels
In the Output Mix Routing Page. The default state for
each input source is stereo, with two channels of input,
streaming through a two-channel output.
There are 4 different options for routing an input signal to
an output. These selections pertain to the operation of a
specific input source routed to a specific output. The
setting is not global, and must be set for each output that
is being used.
Select the Output channel that you wish to listen to, then
press the desired input source (in this example, Line In).
Then tap the Stereo button under the input meters. You
can now choose between:
• Stereo (default)
• Left –audio from the Left input channel (in this case
Line In Left) streaming to both output channels
• Right –the Right input channel streaming to both
output channels
• Sum – combining both the Left and Right inputs into
one Mono stream which is sent to both the Left and
Right outputs equally. The summed signal is
automatically attenuated by 3dB in order to reduce
the possibility of digital clipping.
The chosen option is shown on the button at the bottom of
the Input meters any time that input channel is selected.
Each input channel can be controlled and assigned
independently for each output.
For example, you can have Line In “Summed” sent to the
Monitor Output, while having Line In “Stereo” assigned
to the Headphone Output. This flexibility allows complex
routing to be achieved very easily.