Visara UCT-L - Manual (Page 61)

707108-001 5-13
Chapter 5. 1490 Twinax Emulator
1490 Miscellaneous
Normally the 1490 emulator is running with the Twinax communications active over
the Twinaxial cable to the mainframe host controller. For instances where the user may
want to change a configuration item such as keyboard type (104 to 122), this screen
provides the ability to make modifications to the emulator without powering off the
UCT-L and then powering it back on.
The user may make all the desired menu changes first. Some of the menu items only
take effect during the initial exchange of data with the controller.
Restarting the 1490 Emulator
1. Click Setup in the upper left-hand corner of the screen to open the 1490 Setup
menu.
2. Click Miscellaneous. The 1490 Miscellaneous screen is shown below.
3. Click Stop Twinax.
4. Click the OK button. This stops the 1490 from responding to the controller and the
menu will be removed from the screen.
CAUTION: All data on the 1490 screen and unprinted data will be lost.
When 1490 screen data is erased the Miscellaneous panel will disappear and the cursor
is placed in the upper right corner of the screen.
5. To open the miscellaneous menu, repeat steps 1 and 2.
6. Click Start Twinax.
7. Click the OK button to restart the Twinax communications and initiate the exchange
of configuration items with the controller.